Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks SmartLock '03-Early 04 - Manual (Page 2)

1.
For ease of installation of
your SmartLock Trans Brake,
please read this 12-page Owner’s
Manual before starting any work.
Become thoroughly familiar with
all components and phases of the
installation before beginning any
work.
2.
Inspect all components supplied
for any foreign material that may
have entered during shipping and
handling.
3.
The installation should be
performed at a time when the vehicle
has been allowed to completely cool.
This installation requires the installer
to work near surfaces that may
remain hot after the vehicle has been
run. Failure to allow the vehicle to
cool may result in personal injury.
4.
Pay particular attention to the
routing of wires and hoses. keep
them away from exhaust heat,
moving parts and sharp edges that
may cause cuts or other damage.
Route or tie away from critical
areas as required. keep all wires a
minimum of 6” from hot exhaust
parts, 8” or more is recommended
whenever possible.
warning! Never work under
any vehicle supported only by
a jack of any kind. DO NOT
USE concrete blocks or other
masonry items that may collapse
under the vehicle weight.
System Includes:
• SmartLock Trans Brake
• Pneumatic line pressure boost
actuator assembly
• SmartLock Wiring harness
• Push Lock Tee-Fitting (2)
• 90 degree Swivel Push Lock Fitting (2)
• Air Hose
• Female Spade Connector (1)
• Male Spade Connector (1)
• T-Tap Connector (2)
• Cable Tie (1)
• Owner’s manual
• Warranty Statement
• Product Registration Card
Tools Required:
• Wrench: 1 ⁄
4
” , 7 ⁄
16
” , 1 ⁄
2
” , 9 ⁄
16
”
• Deep socket: 1 ⁄
4
” , 3 ⁄
8
” , 7 ⁄
16
” , 1 ⁄
2
” , 9 ⁄
16
”,
10mm, 13mm
• Side cutter
• Pliers
• Wire stripper and crimpers
• Phillips screw driver
• Extension:
1 ⁄
4
” and 3 ⁄
8
” drive
• Utility knife
• Water resistant lithium grease
2 |
9 6 9 7 6 v . 2 . 0
Dear Customer,
Your new Banks
SmartLock is an integrated
electronic control
that seamlessly locks
the torque converter,
raises transmission
line-pressure, reduces
transmission temperatures
and optimizes braking
performance.
If you have any questions
concerning the installation
of the Banks SmartLock
Trans Brake, please call
our Technical Service
Hotline at (888) 839-2700
between 7:00 am and
5:00 pm (PT). If you have
any questions relating to
shipping or billing, please
contact our Customer
Service Department at
(888) 839-5600.
Thank you.
General Installation
Practices
warning!
DO NOT install the Banks
SmartLock if either one of
the following applies:
1) The Powertrain Control
Module (PCM) is not located
on the passenger side
firewall behind the battery.
(Figure 11).
2) The engine is a high-
output (325-hp rated)
engine.