Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks SmartLock '03-Early 04 - Manual (Page 5)

lever is also tightened.
10.
Inspect the end of the supplied
pneumatic hose and ensure that the
end of the hose is free from burrs
and is cut squarely. The hose can be
trimmed with a sharp knife or razor
blade. Avoid cutting the hose with
scissors or side cutters because it will
collapse the hose before it cuts and may
cause a pressure leak in the future.
11.
Locate the vent air line on the
Banks Brake. It is the air hose running
from the Banks Brake assembly
housing to the breather assembly.
Align a push lock tee-fitting on the
vent hose so the tee-fitting points
directly at the 90-degree swivel push
lock fitting on the rear of the actuator
control assembly (the fitting farthest
away from the actuator bracket).
Mark this location on the hose and
cut it with a sharp knife or razor.
Remove 1” from the air hose. Install
the tee-fitting. See Figure 6.
12.
Insert the provided air hose into
the 90-degree swivel push lock fitting
on the rear of the actuator control
assembly. Route the air hose toward
the tee fitting just installed. cut the
air hose and insert it into the tee
fitting. NOTE: Ensure the length of
the hose is long enough for proper
routing and sealing. For proper
installation, it is required to insert
air hose
1 ⁄
2
” into the push lock fitting.
See Figure 6.
13.
Locate the compressor air hose
to the Banks Brake. It is the air hose
running from the Banks compressor
panel to the Banks brake assembly
housing (it should be next to the vent
air hose). Align a push lock tee-fitting
on the vent hose so the tee-fitting
points directly at the 90-degree
swivel push lock fitting on the front of
actuator control assembly (the fitting
closest to the actuator bracket). Mark
this location on the hose and cut it
with a sharp knife or razor. Remove
1” from the air hose. Install the tee-
fitting. See Figure 6.
14.
Insert the provided air hose into
the 90-degree swivel push lock fitting
on the front of the actuator control
assembly. Route the air hose toward
the tee fitting just installed. cut the air
hose and insert it into the tee fitting.
NOTE: Ensure the length of the hose
9 6 9 7 6 v . 2 . 0
| 5
Figure 5
Figure 6
BREaTHER
aSSEMBLY
FRONT
FITTING
VENT LINE
REaR
FITTING
COMPRESSOR
aIR HOSE
aPPLY GREaSE
RETURN
SPRING