Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks SmartLock '03-Early 04 - Manual (Page 9)

28.
Peel the protective backing from
the foam tape on the SmartLock
Trans Brake module. The SmartLock
Trans Brake should be oriented so
that the electrical connector is facing
down toward the floor of the vehicle.
Attach the SmartLock Trans Brake
to the aluminum frame. Apply light
pressure to the Trans Brake box by
hand for approximately 60 seconds
to seat the foam tape and create a
strong bond.
29.
Locate a stud bolt on the left of
the bottom of the steeling column
and attach the black SmartLock wire
with ring terminal to it. Bolt the
terminal on with the supplied set of
5 ⁄
16
” washer, 8mm lock washer, and
8mm nut. See Figure 14.
30.
Re-install the electric connector
bracket on the left hand side of the
support below the steering column.
31.
Re-install the lower dash panel
with the original screws.
32.
Re-install the black wire
connector with the original screws
and plastic retainers.
33.
Re-connect the previously
disconnected ground terminals at
the battery (if there is more than one
battery, re-connect both.
9 6 9 7 6 v . 2 . 0
| 9
Figure 13
Figure 14