Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks SmartLock '03-Early 04 - Manual (Page 8)

22.
Locate the three (3) PcM
connectors on the passenger side as
shown in Figure 11. Find the orange
wire with black stripe on the white
PcM connector (the middle one).
cut the wire. Install a female spade
connector on the side going into the
PCM, and a male spade connector
on the side coming from the
transmission. connect the SmartLock
yellow wire to the PCM side, and the
orange wire to the transmission side.
See Figure 12. Note: Detaching the
PCM connectors might make the task
easier.
23.
Find the gray wire with black
stripe on the entirely black PcM
connector (the bottom one). Install
a T-tap on the wire and connect the
SmartLock violet wire to it.
24.
Find the orange wire with
white strip on the partially gray PcM
connector (the top one). Install a
T-tap on the wire and connect the
SmartLock pink wire to it.
25.
Route the red wires along the
fender on the driver side behind the
battery tray toward Banks Brake.
Disconnect the green wire on the
Banks Brake compressor. connect
SmartLock red wire female to the
green Brake male, and SmartLock red
wire male to the green Brake female.
26.
Inside the cab, locate the end of
the wire harness with the white 10-pin
connector. Plug this connector into
the SmartLock Trans Brake module.
27.
Locate the cast aluminum
support frame surrounding the
steering column under the dash. The
inside vertical surface of the frame
just to the left of the steering column
will be used to mount the SmartLock
Trans Brake module. See Figure 13.
Ensure the surface is clean and free
of oil, grease and dirt. Clean and dry
using a cloth dampened with rubbing
alcohol or similar cleaning solution.
8 |
9 6 9 7 6 v . 2 . 0
Figure 11
Figure 12
SMaRTLOCK
ORaNGE wIRE
SMaRTLOCK
YELLOw wIRE
INSTaLL
FEMaLE SPaDE
CONNECTOR
INSTaLL
MaLE FaST-ON
TaP CONNECTOR