Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks SmartLock '03-Early 04 - Manual (Page 3)

warning!
DO NOT install the Banks
SmartLock if either one of the
following applies:
1) The PCM is not located on the
passenger side firewall behind
the battery. See Figure 11.
The Banks SmartLock is
only designed to work with
PCMs that are located on the
passenger side firewall behind
the battery.
2) The engine is a high-output
(325-hp rated) engines.
Caution:
Installation of the
SmartLock Trans Brake is NOT
complete until Functional Testing,
described on page 10 of this
manual, has been successfully
completed.
PRESSURE BOOST aCTUaTOR
INSTaLLaTION:
NOTE: The following instructions
assume that a Banks Brake system
has been previously installed on the
vehicle.
1.
As a precaution, disconnect the
ground of the battery. If there is more
than one battery, disconnect both.
2.
Screw the two (2) supplied
90-degree swivel push lock fittings
onto the actuator assembly. Do not
over tighten.
3.
Raise and support the vehicle with
properly weight rated safety stands,
ramps or a commercial hoist. Follow
the manufacturer’s safety precautions.
Take care to balance the vehicle to
prevent it from slipping or falling.
When using ramps, be sure the front
wheels are centered squarely on the topsides; place transmission in
park; set the parking brake and place
blocks behind the rear wheels.
9 6 9 7 6 v . 2 . 0
| 3
Installation Procedure
Figure 2
Figure 1