Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks SmartLock '03-Early 04 - Manual (Page 7)

wire harness . From the engine
compartment, push the end of this
wire through the hole cut in the
firewall grommet. NOTE: Taping the
end of the harness to a piece of stiff
wire (i.e. coat hanger) may make
routing the harness through the firewall a simpler task. The stiff wire
should be pushed through the slit
in the grommet and then the wires
can be attached to the stiff wire
and pulled through the hole in the
firewall.
CaUTION: Pull gently to avoid
damage to the wire harness
connectors. always pull on
the wire harness convolute
sheath rather than the wires
themselves.
20.
From inside the vehicle, continue
to pull the harness through the
firewall until the main harness joint
containing the two (2) red wires
comes through.
21.
In the engine compartment,
route the SmartLock wire harness
end that contains the yellow, orange,
violet and pink wires along the top
of the firewall toward the PcM on
the passenger side. Undo the clips
(10 locations) that run along the top
of firewall and lay the wires next to
the factory wires. See Figure 10.
Use cable tie to secure the inlet and
outlet of the SmartLock harness to the
factory harness.
9 6 9 7 6 v . 2 . 0
| 7
Figure 9
Figure 10
Remove
bracket
SmartLock harness
will come through
here