Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger System & EconoMind, '06-07 Compatible with Banks iQ User Manual
Page 17
96822 v.4.0
17
39.
If your vehicle is NOT equipped
with a factory ground strap on the
intake heater, install the supplied
ground strap from the intake heater
to the engine. Put a 6-mm washer
onto the bottom intake heater
stud, leaving the factory heater nut
installed. Next, install the smaller
diameter ground strap terminal over
the stud and retain with a 6-mm
washer and nut. Route the other end
of the ground strap to the threaded
section on the engine and retain with
a SAE washer and M8- 1.25x 16 bolt.
See Figure 14.
40.
Slide the supplied intake gasket
over the four studs, then slide the
High-Ram over the studs.
41.
Install the supplied Stat-O-Seal
washers on the two driver side
(longer) studs. Driver side studs are
longer than passenger side studs.
The washers should be installed in
a twisting motion to prevent tearing
their sealing element. Install the
supplied
5
⁄
16
” flat washer on all
studs, then fasten with the supplied
5
⁄
16
-24 nylock nuts. The nuts should
be tightened to 12 ft-lbs (144 in-lbs).
An exploded view of the High-Ram
assembly is shown in Figure 15.
42.
Gently bend the engine oil
dipstick tube to it’s mounting location
on the High Ram as shown in Figure
15. Secure the dipstick tube with
the factory bolt that was previously
removed.
43.
Remove rag that was used to
cover the boost tube opening. Make
the connection between the driver
side boost tube and the High-Ram.
Tighten all the driver side hose
clamps to 5 ft-lbs (60 in-lbs).
-END, SEcTION 2-
1
/
2
INTAKE HEATER
M6 NUT & M6
WASHERS (2)
M8 X 1.25 BOLT
SAE WASHER
LARGER
DIAMETER
TERMINAL
GROUND STRAP
FACTORY NUTS
Figure 14. High-Ram stud installation.
Figure 15. Exploded view of the High-Ram assembly