Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger System & EconoMind, '06-07 Compatible with Banks iQ User Manual
Page 23
96822 v.4.0
23
14.
Remove the fuse box cover,
located in left front side of the engine
compartment. Locate the mini-fuse
#28 and remove it. Install the mini-
auto blade tap onto the removed
mini fuse as shown in Figure 27.
Re-install the mini fuse with the
attached blade tap into location #28
as shown in Figure 28. Plug in the
terminal to the mini-auto blade.
Note: Install the mini-auto blade tap on
the terminal leg closest to the engine.
This is the “hot” side of the circuit.
Caution: It is very important that
you select the proper fuse. The
Banks EconoMind Diesel Tuner
will not function properly if
installed incorrectly.
15.
connect the Red and Yellow
thermocouple wires on the
EconoMind wire harness with the
Red and Yellow lead wires on the
thermocouple.
Note: Go over the entire installation as
a precautionary check to ensure that
all clamps are tight, wiring and hoses
are properly routed, and connections
are correct and tight. Make sure that
the EconoMind wire harness is not
lying in the way of the brake and gas
pedals, or any moving parts.
16.
Make sure the fuse box cover
surface is clean and free of dirt and
oil before mounting the EconoMind
Diesel Tuner. clean and dry as
required using a cloth dampened
with rubbing alcohol or a similar
cleaning solution.
CAuTIoN: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result. Mount the EconoMind
Diesel Tuner on the top of the
fuse box cover as shown in Figure
1, by peeling the protective
backing off the adhesive tape on
the back of the EconoMind Diesel
Tuner.
17.
Hold the EconoMind Tuner
against the fuse box cover for
approximately 1 minute while applying
pressure to allow the adhesive to
properly adhere to the surface.
-END, SEcTION 5-
Figure 27
Figure 28