Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger System & EconoMind, '06-07 Compatible with Banks iQ User Manual
Page 22
22
96822 v.4.0
CAuTIoN: The Camshaft Position
(CMP) sensor and the Crankshaft
Position (CKP) sensor have the
same type of connectors and
they are in close proximity to
one another. Make sure the
right connectors are used when
installing these connections.
Refer to Figure 24 for their
locations on the EconoMind
Diesel Tuner wire harness.
12.
Locate the crankshaft Position
(cKP) sensor on the lower front left
side of the engine. It is behind the
engine crankshaft pulley (engine
harmonic balancer). Unplug the
factory connector and plug it into
the corresponding male cKP sensor
connector on the EconoMind
harness. Plug the EconoMind’s
female cKP sensor connector into
the sensor. Take care to route the
wire harness away from the power
steering pump pulley and secure
it with the supplied cable ties. See
Figure 25.
13.
Locate the camshaft Position
(cMP) sensor below the fuel
injection pump between the timing
gear cover and the EcM. Unplug
the factory connector and plug it
into the corresponding male cMP
sensor connector on the EconoMind
harness. Plug the EconoMind’s
female cMP sensor connector into
the sensor. See Figure 26.
Figure 24
Figure 25
Figure 26