Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger System & EconoMind, '06-07 Compatible with Banks iQ User Manual
Page 24
24
96822 v.4.0
If not installing the optional Banks
iQ, skip to Section 7.
WARNING: Below 32
o
F (0
o
C) or
above 140
o
F (60
o
C), the Banks iQ
may be susceptible to damage
as a result of extended direct
exposure to sunlight, heat
or extreme cold. It is highly
recommended that the Banks iQ
be removed from its mounting
location if the vehicle will be
subjected to high concentrations
of sunlight, heat or cold for
an extended period of time.
Gale Banks Engineering is not
responsible for damage to Banks
iQ resulting from exposure
conditions.
CAUTION: Do not use force when
working on plastic parts. Permanent
damage to the part might result.
1.
Locate the Window Mount
Assembly in your kit.
2.
Assemble the Banks iQ docking
station to the Universal mount by
inserting and sliding the Universal
mount tab into the docking station
groove. Hand tighten the nut behind
the docking station to hold the
docking station in place.
3.
Attach the window mount to your
Banks iQ. See Figure 30. Align and
place the two (2) lower tabs on the
window mount to the corresponding
slots on the bottom of Banks iQ first
then snap the top of Banks iQ into
place.
Note: There may be a snug fit when
installing the Banks iQ into the window
mount. Take care not to force this
process.
4.
Find a suitable place on the
windshield for ease of access and
viewing of Banks iQ. Use location
shown in Figure 31 as a reference
for mounting Banks iQ in your
vehicle. Loosen the knob and move
the swivel suction plate to achieve
desired viewing angle of the Banks
iQ screen. Do a test fit and note
the angle necessary to achieve the
correct viewing angle.
5.
Make sure the suction cup and
the mounting area on the windshield
are clean and dry. With the suction
lever in the up position, ensure
the suction cup is flat against the
windshield, and then push the
suction lever down to secure in
place.
6.
Next, remove and set the side
dash access panel aside.
7.
Locate the RJ12 cable (similar
to telephone connector) previously
secured behind the knee panel.
Remove the knee panel to gain
access to the RJ12 cable. See Figure
32.
8.
Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
bridge module. See Figure 33.
9.
Route the Banks iQ USB interface
cable from the Banks iQ bridge
module under the dash and out
through the side access panel
opening. The cable can be slid under
the door frame’s seal and run up
to the top of the dash. Pull enough
cable to reach the Banks iQ and
connect it to the USB receptacle on
the left side of Banks iQ. See Figure
31. Snap the side access panel back
in place making sure not to pinch the
wire.
Section 6
MouNTING AND CoNNECTING THE BANKS iQ
Figure 30 Attaching Banks iQ to window mount
Figure 31 Mounting location for Banks iQ