Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger System & EconoMind, '06-07 Compatible with Banks iQ User Manual
Page 21
96822 v.4.0
21
CAuTIoN: Pull gently to avoid
damage to the cable connectors.
Always pull on the cable sheath
rather than the wires themselves.
7.
From inside the vehicle, continue
to pull the in-cab cable through the
firewall until it is approximately 22”
inside the cab. Secure the cable
to the lower access panel area.
Take precaution to leave the three
connectors accessible for usage
further in the installation process.
8.
Locate the OBD II connector and
remove it from the sheet metal panel
by pressing the outer tabs in. Now,
push the connector out. See Figure
21.
9.
Locate the Banks OBDII Interface
cable and 11” cable tie in your kit.
connect the OBDII Interface cable to
the vehicle OBDII connector. Use the
11” cable tie as shown in Figure 22
to secure the Banks interface cable
to the vehicle OBDII connector. Now,
connect the 8-pin connector from the
Banks OBDII Interface cable to the
8-pin connector on the EconoMind
Tuner in-cab cable.
Note: If you are not installing the
optional Banks IQ then coil up and
secure the cable with the RJ12
(telephone style) connector end.
10.
In the engine compartment find
the Fuel Rail Pressure (FRP) sensor
on the fuel rail. It is located on the
drivers side of the engine. Unplug
the factory connector and plug it
into the corresponding male FRP
sensor connector on the EconoMind
harness. Plug the EconoMind’s
female FRP sensor connector into the
sensor. See Figure 23.
11.
Locate the Manifold Pressure
(MAP) sensor on top of the intake
manifold. Unplug the factory
connector and plug it into the
corresponding male MAP sensor
connector on the EconoMind
harness. Plug the EconoMind’s
female MAP sensor connector into
the sensor. See Figure 23.
Figure 22
Figure 21
Figure 23