Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Pack & Stinger System & EconoMind, '06-07 Compatible with Banks iQ User Manual
Page 20
20
96822 v.4.0
1.
Place the EconoMind Diesel
Tuner box on top of the fuse box
located in the left front side in the
engine compartment. See Figure
18. The in-cab cable with the three
small connectors will be routed into
the cabin via the grommet on the
firewall. The other two harnesses
will be routed under the intake to
their respective locations listed in the
following steps.
2.
Locate the rubber grommet on
the drivers side firewall. Using a
utility knife, make a 1.5-inch-long
slit in the grommet next to the wire
harness. Be careful not to cut or
damage the harness. See Figure
19 for the proper location of the
required cut. Insert a screwdriver
from the engine compartment into
the cut hole and gently thrust it
through the grommet.
3.
Inside the vehicle, remove the
lower dash panel beneath the
steering column by removing the
two (2) screws at the bottom of
the panel. Retain the screws for
reinstallation.
NOTE: There are also two (2) clips
located at the top corners of the
panel, which hold the panel in place.
These clips can be released by gently
pulling on the corners of the panel.
Use caution to avoid damaging the
panel during removal.
4.
Remove the electrical connector
bracket on the left hand side of the
support below the steering column
in front of the firewall by removing
the two (2) bolts. This will allow
access to the inner grommet. See
Figure 20.
5.
cut the grommet on the firewall
inside the vehicle along the hole
created by the screwdriver in Step
2.
6.
Locate the in-cab cable with the
three connectors. From the engine
compartment, push the in-cab cable
through the hole cut in the firewall
grommet.
NOTE: Taping the end of the cable to
a piece of stiff wire (i.e. coat hanger)
may make routing the cable through
the firewall a simpler task. The stiff
wire should be pushed through the
slit in the grommet and then the
wires can be attached to the stiff
wire and pulled through the hole in
the grommet.
Section 5
BANKS ECoNoMIND DIESEL TuNER INSTALLATIoN
Figure 18
Figure 19
Figure 20