Brake enable switch installation – Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake, Exhaust Brake System, Late '04-07 For use w_Manual Transmissions User Manual
Page 25
97232 v.3.0
25
CAUTION: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
Note: Before drilling, confirm that
there is adequate room for the Brake
enable Switch and wires behind the
dash. Make sure wires or obstructions
are cleared from the drilling area.
From where the Brake enable Switch
will be located, make sure there is
enough wire on the Banks Wiring
Harness to reach the Switch.
these are just suggested locations. It
is possible to locate the Brake enable
Switch where it is more comfortable.
Please confirm space behind dash
before drilling.
2004-2005 Brake Switch install
1.
The Banks Brake Enable Switch can
be installed in one of two places. #1,
on the drivers side of the instrument
panel (IP) next to the steering column
(Figure 25) or #2, on the knee panel
above the brake release (Figure 26).
2.
Location #1: Remove the
headlamp switch bezel on the driver’s
side by gently pulling on it. Disconnect
the electrical connector once the bezel
is removed.
3.
To remove the center bezel,
open the ashtray and cup holder and
remove the retaining screw. Gently
pull on the center bezel to disengage
all the clips that attach the bezel
to the dash. Disconnect the four
(4) electrical connections after the
bezel is removed. Keep the screw for
reinstallation.
Section 6
Brake Enable Switch Installation.
Figure 25 Location #1