Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake, Exhaust Brake System, Late '04-07 For use w_Manual Transmissions User Manual
Page 26
26
97232 v.3.0
4.
Remove the cluster bezel by first
removing the two (2) screws at the
top. Gently pull on it and disengage
all the clips that attach the bezel
to the dash. Retain the screws for
reinstallation.
5.
Cut out the supplied template
(Figure 32) and align the template
onto the front of the cluster bezel by
placing its left edge against the cluster
rib, and it’s bottom edge against the
cluster bottom edge. Use masking
tape to securely hold down the
template.
Note: Do not tape over the markings
on the template.
It may be necessary to trim some of
the cluster’s ribs for the Switch to fit.
Skip to Step 12.
6.
Location #2: Remove the dash
side panel (Figure 27). Remove the 2
screws inside.
7.
Remove the 2 screws at the
bottom of the center knee panel. Pull
at the top to disengage the clips that
hold the knee panel.
8.
Pull at top of the left brake panel
to disengage it’s clips. If applicable,
disconnect any switch wires. Remove
the panel from the truck.
9.
Cut out the supplied template
(Figure 33) and align the template
onto the rear of the brake panel
by placing it’s upper edge against
the upper edge of the panel. Refer
to Figure 28. Use masking tape to
securely hold down the template.
Note: Do not tape over the markings
on the template.
Skip to Step 12.
Figure 26 Location #2