Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Brake, Exhaust Brake System, Late '04-07 For use w_Manual Transmissions User Manual
Page 29
97232 v.3.0
29
drill through the panel. Remove and
discard the template and any plastic
shavings.
Note: It is important that the hole
is drilled as close as possible to the
recommended location. the switch
may not clear the instrument panel
structure if the hole is shifted to
another location.
A pilot hole may be drilled first if a Uni-
bit is unavailable. Use a drill bit smaller
than
1
/
2
”.
13.
Align the Banks Brake Enable
Switch label over the previously drilled
hole. Make sure the entire mounting
surface is clean and free of dirt and
oil before mounting the label. Clean
and dry as required using a cloth
dampened with rubbing alcohol or
similar cleaning solution.
CAUTION: Do not get any fluid
directly onto/into any electrical
equipment or equipment damage
may result.
14.
Mount the Banks Brake Enable
Switch label onto the panel by peeling
off the protective backing from the
adhesive tape on the back of the
switch label. Hold the label against the
panel for approximately 20 seconds
while applying pressure to allow the
adhesive to properly adhere to the
surface.
15.
Attach the Brake Enable Switch
wires to the Switch (BLACK to 1,
BLACK-RED to 2, RED to 3) as shown in
Figure 31.
16.
Remove the chrome bezel nut
from the Switch shaft. Insert the
Switch shaft into the hole that was
drilled in the dash panel. Re-install the
chrome bezel nut.
17.
Reconnect any electrical
connectors and re-install the
instrument panel(s).
18.
Plug the Switch’s Connector into
the Banks Brake Wiring Harness Switch
Connector.
Figure 30