Grain Systems Unload Augers PNEG-790 - Manual (Page 6)

6 Pneg - 790 Commercial Bin Well Control Rod Kits & Rack & Pinion Controls
1. SAFETY
Safety Instructions
GSI’s principle concern is your safety and the safety of others associated with grain handling
equipment. We want to keep you as a customer. This manual is to help you understand safe
operating procedures and some problems which may be encountered by the operator and other
personnel.
As owner and/or operator, it is your responsibility to know what requirements, hazards and
precautions exist, and to inform all personnel associated with the equipment or in the area.
Safety precautions may be required from the personnel. Avoid any alterations to the equipment.
Such alterations may produce a very dangerous situation, where SERIOUS INJURY or DEATH
may occur.
This equipment shall be installed in accordance with the current installation codes and applicable
regulations which should be carefully followed in all cases. Authorities having jurisdiction should
be consulted before installations are made.
Operate Unload Equipment Properly
Make sure ALL equipment is locked in position before operating.
NEVER start equipment until ALL persons are clear of the work area.
Use caution not to hit the auger when positioning the load.
Be sure all operators are adequately rested and prepared to perform all functions of operating
this equipment.
Untrained operators subject themselves and others to SERIOUS INJURY or DEATH. NEVER
allow untrained personnel to operate this equipment.
Keep children and other unqualified personnel out of the working area at ALL times.
NEVER allow any person intoxicated or under the influence of alcohol or drugs to operate the
equipment.
NEVER work alone. Make sure someone is nearby who is aware of the proper shutdown
sequence in the event of an accident or emergency.
ALWAYS think before acting. NEVER act impulsively around the equipment.
NEVER allow anyone inside a bin, truck or wagon which is being unloaded by an auger or
conveyor. Flowing grain can trap and suffocate in seconds.
Use ample overhead lighting after sunset to light the work area.
Keep area around intake free of obstacles such as electrical cords, blocks, etc. that might trip
workers.
NEVER drive, stand or walk under the equipment.
ALWAYS lockout ALL power to the equipment when finished unloading a bin.
Be aware of pinch points. A Pinch point is a narrow area between two surfaces that is likely to
trap or catch objects and so is a potential safety hazard.
Operate Unload
Equipment Safely