Grain Systems PNEG-900 - Manual (Page 8)

8 PNEG-900 Series 2000 Autoflow Fan/Heater and Control Installation Instructions
2. Decals
The GSI recommends contacting your local power company and having a representative survey the
installation so the wiring is compatible with their system and adequate power is supplied to the unit.
Safety decals should be read and understood by all people in the grain handling area. The rotating blade,
fire warning decals and voltage danger decal must be displayed on the fan can. The decal DC-GBC-1A
shown
on Page 9 should be present on the inside bin door cover of the 2 ring door, 24" porthole door cover
and the roof manway cover.
If a decal is damaged or is missing contact:
GSI Decals
1004 E. Illinois St.
Assumption, IL. 62510
Phone: 1-217-226-4421
A free replacement will be sent to you.
Roof Damage Warning and Disclaimer
The manufacturer does not warrant any roof damage caused by excessive vacuum or internal
pressure from fans or other air moving systems. Adequate ventilation and/or “makeup air” devices
should be provided for all powered air handling systems. The manufacturer does not recommend
the use of downward flow systems (suction). Severe roof damage can result from any blockage of
air passages. Running fans during high humidity/cold weather conditions can cause air exhaust
or intake ports to freeze.
Excessive vacuum (or pressure) may
damage roof. Use positive aeration
system. Make sure all roof vents are
open and unobstructed. Start roof
fans when supply fans are started.
Do not operate when conditions exist
that may cause roof vent icing.
DC-969
CAUTION
GSI Group, Inc. 217-226-4421