Grain Systems Tanks PNEG-4075G User Manual
Page 121
Advertising
18.Align the holes in the splice plate (J) and side cap plate (L) with the holes in the long center collar
channel (I), and install six bolts (N) and nuts (P) into the outer row of holes, working outward from the
center of the splice plate.
19.Repeat this procedure for the other side of the center cap plate (Q).
20.Locate the third hole from each end of the spice plates (J), and install four vendor lifting eyebolts (O),
NOT supplied by GSI, and nuts (P).
NOTE: Eyebolt will pass through three layers of steel: the splice plate (J), the center cap plate (Q),
and the long center collar channel (I).
21.Tighten all hardware to the recommended torque specifications. See
Pneg-4075G 75 Ft Diameter 40-Series Bin
121
Advertising