Series 2000 autoflow fan / heater – Grain Systems PNEG-1314 User Manual
Page 38
Advertising
2003 Top Dry Service School
3 8
Diagnostic Mode
•
Turn the Control Power “ off “.
•
Hold down the Program Tempera-
ture switch.
•
Turn the Control Power switch “on “
with the Program Temperature switch
held down.
•
Press the Program Dry time switch to
engage the Fan Starter.
•
Press the Program Temperature switch
to start theIgnitor.
•
Press the Hours x 1000 switch to open
the Ssolenoid.
•
Turn the control power “off” to exit
the Diagnostic mode.
CAUTION: DO NOT ATTEMPT BELOW PROCEDURE WITH GAS LINE CONNECTED.
Series 2000 Autoflow Fan / Heater
Advertising