Assembling the chain guard, Installation – Grain Systems PNEG-1894 User Manual
Page 13
4. Installation
PNEG-1894 Top Dry Chute Controller
13
Assembling the Chain Guard
1. Position the chute controller assembly so that all sides are accessible. Remove the cover from the
chute position controller enclosure.
2. Align the top and bottom tabs of the rear chain guard (B) with holes in the idler sprocket mounting
brackets (C) and attach by inserting flange bolts (D) through the sides and tightening with flange
nuts (E).
3. Feed chain (A) that is part of the chute position controller drive from the chute position controller
around the small sprocket and out through the back panel and in between the idler sprocket mounting
brackets (C).
4. Replace cover and secure for lifting.
Figure 4F
Ref #
Part #
Description
A
TD-101357
#40 Roller Chain
B
TD-101336
Rear Chain Guard
C
TD-101332
Idler Sprocket Mounting Bracket
D
S-6606
Flange Bolt 5/16"-18 x 3/4" ZN Grade 5
E
S-3611
Flange Nut 5/16"-18 YDP Grade 2