Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1056 User Manual
Page 13
- 13 -
Installation
The following guidelines dealing with the installation of the Series I incline conveyors are
provided for your convenience. The company cannot be held responsible for the installation of
this unit.
Clearance
A clearance of at least the width of the conveyor is recommended on all sides of the unit. This
amount of clearance is not a necessity; less clearance maybe acceptable. However, serious
consideration must be given to methods of maintenance, removal and replacement of the
conveyor and/or its parts.
Support & Welding
No welding of any kind on or to the conveyor is recommended. Welding on or to the conveyor
may cause damage to both the conveyor and its electrical system. If welding is necessary, the
manufacturer prefers that the attachments or supports be welded to bottom splices. Should it be
necessary to fasten anything to the conveyor permanently, careful consideration should be given
to methods of maintenance, removal and replacement of the conveyor and/or its parts.