Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1056 - Manual (Page 23)

- 23 -
Take-up rod should have one welded nut already in place. Place another nut on rod and insert
into take-up anchor. Place two nuts onto take-up rod and insert into take-up bearing weldment.
Finish by placing nut with pre-drilled hole on rod, place roll pin through nut and rod.
Attach discharge transition weldment to head side panels using 3/8”hex head bolts and 3/8”
whiz nuts. Then attach discharge transition splice plate between head bottom panel and
discharge transition. If a bottom liner is specified, a spacer between the head bottom panel and
the discharge transition splice is furnished, and should be properly positioned between these two
components before fasteners are inserted.
Center sprocket between head side panels and tighten all setscrews.
Place cover assembly on top of conveyor and fasten with 3/8” hex head bolts and 3/8” whiz
nuts.
Incline ConveyorTail Section Sub-Assembly
Assembly sequence for incline tail section sub-assembly.
Fasten tail bottom panel to each tail side panel using 3/8” hex head bolts and 3/8” whiz nuts.
Whiz nuts should be located on bottom side of conveyor. The tail bottom panel should be
recessed approximately two inches.