Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1128 - Manual (Page 24)

6. Installation
24 PNEG-1128 Chain Loop System without Controls
Chain Loop Torque Arm Repair Kit (Continued)
Place the C-clamp bracket to the back side of the square tubing. (See Figure 6E.)
Figure 6E
Place the torque plate anchor bracket between the torque plate assemblies and attach it to the C-clamp
using the 3/8"-16 hardware.
(See Figure 6F.)
NOTE: Leave the hardware loose to allow for ease of assembly.
Figure 6F