Install procedure – Grain Systems PNEG-1745 User Manual
Page 11
Advertising
3. Installation
PNEG-1745 WatchDog
11
Install Procedure
This installation takes place in the lower control panel of the Vision system. Follow the steps listed below
to install the components:
1. Turn OFF power to dryer and control panel.
2. If a cellular modem is being installed, first refer to
for a few extra instructions
and then return here.
3. Place mounting plate with WatchDog circuit board attached over two (2) existing bolts on the right
side of the lower control panel. Secure it using the two (2) 1/4" nuts supplied. Position the mounting
plate so the white sticker is in clear view.
Figure 3D
Mounting plate with
WatchDog circuit board
Advertising