Grain Systems PNEG-1745 - Manual (Page 42)

5. WatchDog Software Update
42 PNEG-1745 WatchDog
11. After turning the WatchDog power OFF, insert the SD Card into the WatchDog board as
shown in Figure 5I .
Figure 5I
12. Once the SD Card is securely placed in the reader, return power to the WatchDog board and allow
3 minutes to pass.
13. After 3 minutes have passed, turn the WatchDog power OFF and then remove the SD Card from
the board.
14. Return power to the WatchDog board and wait for the red “SYS” light to come ON. The WatchDog is
now updated.