Grain Systems PNEG-1745 User Manual
Page 16
3. Installation
16
PNEG-1745 WatchDog
The default password is default. The password is the same as is used to access the WatchDog.
Therefore, if the user has changed the password, the setup password will be whatever they have changed
it to. If the user forgets his/her password, see the user manual for resetting the password.
Once logged in,
should be displayed on the screen.
Figure 3K
The current setup is displayed to the left of this screen. The address will differ from
. If the device
is setup as a DHCP Client and the IP address that is displayed is “10.11.12.1”, this means the DHCP
Server did not serve the board an IP address. If you were expecting the board to pull down an IP address,
reset the power on the modem/router and then the WatchDog board. If these addresses need to be
modified, click the “Configure” button to the right. This will take you to
.
Figure 3L