Grain Systems PNEG-1745 - Manual (Page 29)

4. WatchDog Operation
PNEG-1745 WatchDog 29
Default Operation Screen
The screen in Figure 4C will be displayed, unless the dryer is shutdown, upon connection to the dryer if it
is a tower dryer. This very closely resembles how the screen would appear at the dryer. All the buttons
function exactly as they would if pressed on the dryer screen, except for the Setup and View buttons.
These buttons on this screen allow changes to be made to the setup of the WatchDog System and to view
information related to the WatchDog System. The menus/information below each button will be described
more fully in the following sections.
Figure 4C
All information displayed around the dryer picture, is exactly as it would appear on the dryer screen. The
lower right 1/4 of the screen shows the state of each burner, once again, as it would be displayed at the
dryer. The log of temperatures and moistures on the right hand side of the screen functions exactly as it
does at the dryer, but the data displayed may be different. (It is not downloaded from the dryer.) Finally,
the status bar displayed in the upper right hand corner gives the current status of the dryer and shows the
same information that is presented at the dryer.
Table Sample Time Button
Pressing the button in the upper left hand of the table view will bring up the screen shown in
Figure 4C . This sets the number of minutes for each sample that is entered into the data log table.
NOTE: If the sample time (See Figure 4D on Page 30) for the WatchDog System is set longer than the
history time interval, the table will miss samples.