Cobalt Digital COMPASS 9062 Up_Down_Cross Converter - Manual (Page 87)

9062-OM (V4.6) 9062 PRODUCT MANUAL 3-55
Operating Instructions
Troubleshooting
9062 Processing Error Troubleshooting
Table 3-4 provides 9062 processing troubleshooting information. If the 9062
card exhibits any of the symptoms listed in Table 3-4, follow the
troubleshooting instructions provided.
In the majority of cases, most errors are caused by simple errors where the
9062 is not appropriately set for the type of signal being received by the card.
Note: The error indications shown below are typical for the corresponding error con-
ditions listed. Other error indications not specified here may also be displayed
on DashBoard™ and/or the 9062 card edge status indicators.
Note: Where errors are displayed on both the 9062 card and network remote con-
trols, the respective indicators and displays are individually described in this
section.
Table 3-4 Troubleshooting Processing Errors by Symptom
Symptom Error/Condition Corrective Action
• DashBoard™ shows Video
yellow icon and Input Invalid
message in 9062 Card Info
pane.
• Card edge Input Format LEDs
show continuous cycling.
No video input present Make certain intended video source is connected
to appropriate 9062 card video input. Make
certain BNC cable connections between frame
Rear I/O Module for the card and signal source
are OK.
• DashBoard™ shows Frame
Sync red icon and Reference
Invalid message in 9062 Card
Info pane.
• Card edge red ERR indicator
illuminated.
Frame sync reference not
properly selected or not being
received • If external frame sync reference is not
intended to be used, make certain the
Framesync Enable selection list is set to Off or
Input Video as desired.
• If external frame sync reference is intended to
be used, make certain selected external frame
sync reference is active on frame bus.
(External reference signals Reference 1 and
Reference 2 are distributed to the 9062 and
other cards via a frame bus.)
Refer to Framesync function submenu tab on
page 3-26 for more information.