Installation and setup – Cobalt Digital COMPASS 9085 Loudness Processor User Manual
Page 29
9085-OM (V4.3)
9085 PRODUCT MANUAL
2-3
Installation and Setup
Installing the 9085 Into a Frame Slot
Note:
If installing the 9085 in a slot with no rear I/O module, a Rear I/O Module is
required before cabling can be connected. Refer to Installing a Rear I/O Mod-
ule (p. 2-4) for rear I/O module installation procedure.
CAUTION
If required, make certain Rear I/O Module(s) is installed before installing the
9085 into the frame slot. Damage to card and/or Rear I/O Module can occur if
module installation is attempted with card already installed in slot.
Note:
Check the packaging in which the 9085 was shipped for any extra items such
as a Rear I/O Module connection label. In some cases, this label is shipped
with the card and should be installed on the Rear I/O connector bank corre-
sponding to the slot location of the card.
Install the 9085 into a frame slot as follows:
1.
Determine the slot in which the 9085 is to be installed.
2.
Open the frame front access panel.
3.
While holding the card by the card edges, align the card such that the
plastic ejector tab is on the bottom.
4.
Align the card with the top and bottom guides of the slot in which the
card is being installed.
5.
Gradually slide the card into the slot. When resistance is noticed, gently
continue pushing the card until its rear printed circuit edge terminals
engage fully into the rear I/O module mating connector.
CAUTION
If card resists fully engaging in rear I/O module mating connector, check for
alignment and proper insertion in slot tracks. Damage to card and/or rear I/O
module may occur if improper card insertion is attempted.
6.
Verify that the card is fully engaged in rear I/O module mating connector.
7.
Close the frame front access panel.
8.
Connect the input and output cables as follows:
•
If the 9085 is being installed in a PN 8310-BNC or 8310-C-BNC
frame, refer to the label on the connector bank corresponding to the
card’s slot location for connector designations.
•
If the 9085 is being installed in a frame using a specific 9085 Rear
I/O Module, connect cabling in accordance with the appropriate
diagram shown in Table 2-1, “9085 Rear I/O Modules” (p. 2-6).
9.