TC Electronic Nova System - Manual (Page 21)

21
MIDI
MIDI Setup menu
Navigation
• Press MENU to enter menu
• Select MIDI Setup menu using Encoder D
• Press MENU to enter
• Change page using encoder D
• Change parameters using encoder C
MIDI Channel
Range: Off, 1 to 16 or Omni
When Omni is selected, the NOVA System receives MIDI
information on all channels. When set to “Off”, the NOVA
System does not respond to any incoming MIDI data.
Program Change In
Range: On/Off
Determines whether the NOVA System should respond
to incoming MIDI program changes or not.
Program Change Out
Range: Off/On
This parameter and the Prg. Map parameter concern the
MIDI program change information sent on MIDI out when
a preset is recalled on NOVA System.
Off: No program changes are sent on MIDI out.
On: Program changes are sent on MIDI out when presets
are recalled.
PrgMap - Program Map
The Program Map function allows you to map an
incoming MIDI program change from an external MIDI
device to recall any preset.
In the following example incoming MIDI program change
#1 will recall preset #2 in Factory bank #0.
Factory presets are labeled “F” and User presets are
labeled 00-1 to 20-3.
The PrgMap settings also apply on MIDI out. So if we
look at the example above. Recalling preset number #2
in factory bank #0 will send program change #1 on MIDI
out.
Prg. Map Reset
Press MENU to reset the Program Map.
SysEx ID
Range: 0 to 126 - ALL
Sets the NOVA System’s SysEx ID for identification in
larger MIDI setups.
Dump System*
For a complete system backup, press MENU. All the
NOVA System’s global settings sent via MIDI as a MIDI
Data Dump. Presets are NOT included - see below.
Dump Bank*
The entire User bank is sent via MIDI as a MIDI Data
Dump when “Execute Dump” is performed.
How to Dump via MIDI – Step by Step:
• Connect the NOVA System’s MIDI Out to the MIDI In
of a MIDI sequencing device.