TC Electronic Nova System - Manual (Page 43)

43
EFFECTS - DELAY
FX Mute - Spill-over
The FX Mute parameter determines how the Reverb and
Delay effects should behave when changing between
presets and when bypassing one of these effects.
The FX Mute parameter is found in the utility menu.
Soft:
Delay and Reverbs will “ring out”
Delays have true spillover, meaning that if you e.g. have
a long delay time and the FX Mute parameter is set to
“Soft” the delays will continue even if you change to a
preset that holds completely different delay settings.
Reverbs can also spill over at preset change but will use
the settings in the new preset.
Hard:
Delay and Reverbs will mute.
Sense – Sensitivity
Range: -50 to 0 dB
The sensitivity parameter determines how soon the delay
repeats should become audible in relation to the Input
signal level. This parameter acts a threshold between
your guitar signal and the delay repeats.
Damp
Range: 0 to 100 dB
As explained in the introduction, the Dynamic Delay
attenuates the delay repeats level based on the present
Input. The Damp parameter sets the amount of
attenuation.
Rel – Release
Range: 20 to 1000 ms
Determines how fast the attenuation of the delay repeats
is released.
Dual Delay
This true Dual Delay lets you set two independent delay
taps, each with its own Tempo parameter, High and Low
cut, as well as a “Pan” parameter.
In addition to the “common” parameters described in
the introduction of the delay section, this delay has
the following parameters:
Pan1 & Pan2
Range: 50L to 50R
Sets the panning position of the delay repeats for delay
lines 1 and 2.