R&M Materials Handling HOIST MONITORS User Manual

Page 105

Advertising
background image

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319

105/105

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

•

Hang the test load in the hook and check the actual load in both slow speed and in fast speed with
parameter 2-1-1. The display should show the value of the test load, ±5% of nominal load.

-

If the load values are within the given range, the work is finished. Return the old unit to the manufacturer.

-

If the displayed load values differ too much (more than 10%) from the actual (test) load, carry out the
calibration procedure as described in Service Manual.

•

After the calibration procedure, check the display values again. If the load values are within the given
range, the work is finished. Return the old unit to the manufacturer.

•

If the new unit shows any fault code, carry out the troubleshooting as described in Service Manual.

•

Return the old unit to the manufacturer.


Advertising