Ironwood Electronics Kelvin testing using GHz socket - Manual (Page 2)

Tel: (800) 404-0204
www.ironwoodelectronics.com
Figure 2: MLF pad detail
Ironwood Electronics, Inc. has developed a socket for MLF device, which has two features
that allow the socket to be used for Kelvin probing in an MLF device. The first feature of the
socket is that it has a very high density contactor which consists of tiny gold plated wires
spaced 0.05mm apart or two thousandths of an inch mounted at a slight angle from vertical in
an elastomer material. This sea of wires provides the connection between two parallel
conductors forced together such as the lead on an MLF and a pad on a PCB with the
contactor between. The second feature is a patent pending method for precisely positioning
the MLF/QFN leads precisely over the pads on the target PCB. This socket was originally
designed as a 10 GHz bandwidth socket for testing very high frequency circuits in MLF/QFN
packages.
To use the GHz MLF socket as a Kelvin measurement device, the target board has to be
designed as shown in Figure 3. Figure 3A shows the layout for use as a standard socket.
Figure 3B shows the layout for use as a Kelvin measurement socket. The difference is that
the pads for Figure 3B are split in the center and a gap of 0.125mm are inserted between the
two sections of the pad. Each fragmentary section of the standard pad or two smaller pads is
then connected to the measuring circuitry as shown in the figure. The current source is
connected to one section of the pad and the sensing circuit is connected to the other section