Ironwood Electronics Pseudo Gull Wing Surface Mount Foot Soldering Instructions - Manual (Page 2)

Page 2 of 2
Pseudo Gull Wing Soldering Instructions
Tel: (800) 404-0204
www.ironwoodelectronics.com
5. Using a microscope, individually solder
each lead of the foot to their pads using solder
sparingly. See soldering process in Figure 4.
Excess solder will collect on the inboard end
of the leads underneath the foot potentially
causing solder bridges to occur between
adjacent legs. Caution must be used when
touching the soldering iron tip to the emulator
foot leads to avoid excessive heat, heating
time and pressure, which may damage the
adaptor or target board pads.
6. After soldering, inspect the foot for proper
fillets and solder bridges using a microscope.
Remove solder bridges using fluxed solder wick.
7. Clean the foot thoroughly using an
aqueous cleaning system and inspect for
proper solder connections as shown in
Figure 5.
filename: PSI.doc, Rev A
Figure 4: Soldering Process
Figure 5: Solder Connections