SCANTECH ID (Champtek company) SG300RFM - Manual (Page 35)

31
>
Setup Code Length
1. Scan the “Set Begin” Bar Code (2 Sets
Available)
2. Go to Decimal Value Table in Appendix A,
scan Bar Code(s) that represents the code
length
3. Scan the “Complete” Bar Code
Repeat Steps 1-3 to set additional lengths
< Variable>
The output would be the
same as the barcode’s length.
There is no limit in length for
the reading output.
Fix Length (2 Sets Available)
1
1st Set Begin
2
Decimal Value Appendix A
3
1
st
Set Complete
1
2
nd
Set Begin
2
Decimal Value Appendix A
3
2
nd
Set Complete
Minimum Length
1
Minimum Length
Set a minimum length
for codes. If the
length of a code is
shorter than the
minimum length, then