SCANTECH ID (Champtek company) SG300RFM - Manual (Page 5)

1
Introduction
1.1 General
SG300RFM has been factory configured with a set of default
parameters. All factory default settings are shown with <> and
bold in the following sections. You may make your own settings
by following procedures in this manual. If you want to save the
settings permanently, you should scan the Bar Code of “Save
Parameters” in chapter 2, otherwise the settings will not be
saved after the scanner power is off, and all settings will back
to previous settings.
By scanning “Set all default” Bar Code, the settings will go
back to the factory default settings.
1.2 EMI certificated
CE standards
The CE mark as shown here indicates this product had been
tested in accordance with the procedures given in European
Council Directive 89/336/EEC and confirmed to comply with
the Europe an Standard EN55022:1994/ A1: 1995 Class B, EN
55024/1998.
1.3 Legislation and WEEE symbol
1