SCANTECH ID (Champtek company) SG300RFM - Manual (Page 39)

35
Minimum Length
1
Minimum Length
Set a minimum length
for codes. If the
length of a code is
shorter than the
minimum length, then
the scanner will not
output the data.
2
Decimal Value Appendix A
3
Minimum Length
Complete
4.13 MSI/PLESSEY Code
> Check Digit Transmission
<Do not Calculate Check
Digit>
Calculate Check Digit and
Transmit
Calculate Check Digit and
Not Transmit
>
Setup Code Length
1. Scan the “Set Begin” Bar Code (2 Sets
Available)
2. Go to Decimal Value Table in Appendix A,
scan Bar Code(s) that represents the code
length
3. Scan the “Complete” Bar Code
Repeat Steps 1-3 to set additional lengths