GE Industrial Solutions CPS6000 - Manual (Page 128)

CPS6000 –48V Indoor/Outdoor Power Shelf
Issue 21 January 2008
128
Network Settings The access type and the Dynamic IP addressing mode are set in this section.
The Dynamic IP address mode sets the IP address operation mode of the
Ethernet port on the QS841A. This port has been set to act in DHCP
(Dynamic Host Configuration Protocol) Server mode in the NX400 in order
to provide the Craft port located at the front of the system. The
QS841A_NX serves up 192.168.2.1 which should be used as the destination
address on the Craft. This configuration should not be changed in the
NX400. The Static and Client modes of operation allow the QS841A’s port
to be configured to operate plugged into the network. Note: once this
parameter is changed, the controller must be re-booted by removing power
from the unit by removing and re-inserting the unit into the shelf.
In addition, there is the ability to Enable or disable Write access for
someone who is attached to the Craft port. The factory default setting is
Enabled.
10/100 Base-T Ethernet Port
The 10/100Base-T Ethernet is designed for remote access and system management but can be
set-up to provide a Craft interface port. When accessing the port with a standard browser
either remotely or as a Craft port all Status, Control/Operation, Configuration, and other
items described previously are available through respective web pages. In addition to
providing a top level Home view of the system depicted below, additional information or
configuration is available that is not available through the front panel. Unlike the front panel
interface which is limited structurally, the Web pages are more dynamic and will be enhanced
over time. Consult factory for latest upgrades.