GE Industrial Solutions CPS6000 User Manual
Page 185
CPS6000 –48V Indoor/Outdoor Power Shelf
Issue 21 January 2008
185
sta Report
Status
Syntax:
sta obj,attr
where: obj,attr is an object-attribute pair. For example, ps1,sid.
Description
This command reports the value of the measurement, configuration, or control parameters in
the system. A couple examples are listed below to illustrate how this command works.
sta dc1,vdcReport plant voltage
sta dc1,adcReport plant load current
The command line would respond as follows for first command listed above.
* sta dc1,vdc
:DC1
VDC=-52.48
.
* _
The “* ” in the example above is the user command line prompt. The line “:DC1” indicates
that the information that follows is for the plant object. The line starting with “VDC” identifies
the DC voltage. The “.” line is the end-of-command identifier.