Controller – GE Industrial Solutions CPS6000 User Manual
Page 43
CPS6000 –48V Indoor/Outdoor Power Shelf
Issue 21 January 2008
43
Controller
Controller Installation
The Controller mounts in the controller housing located on the left side of the CPS shelf,
Figure 5-5. The Controller is field installable, however in most cases it will be factory
installed.
Warning: You must properly protect the Controller against ESD discharge.
Note: There is an ESD cord connection located on the left side of the shelf.
Step Action
1.
Does the CPS shelf have the Controller already installed?
Yes - Proceed to the Rectifier
installation section
No - Continue
2.
Slide the controller into the shelf until it is fully seated in the connector on the
rear of the CPS shelf. See Figure 5-5.
3.
Connect one end of the display cable to the connector on the controller.
Connect the display faceplate to the other end of the display cable. Carefully
dress the display cable when attaching to the shelf to ensure the cable does not
get pinched.
4.
Insert the tab on the bottom of the faceplate into the slot on the bottom of the
controller housing.
5.
Push the display faceplate into the shelf until the latch on the top of the
controller housing catches.