Connecting to the network, Fiber tap, Figure 3: connecting to the network – Net Optics Fiber Taps User Manual
Page 9
Advertising
Fiber Tap
5
Connecting to the Network
1 . Connect Network Port A to the appropriate network device using a Duplex
LC cable .
2 . Connect Network Port B to the appropriate network device using a Duplex
LC cable .
3 . Verify that the Tap Network Ports are cabled in-line between two devices .
Note: ________________________________________________________________
The use of Singlemode (8.5μm), Multimode (50μm or 62.5μm), or LC cabling
is determined by the model purchased.
______________________________________________________________________
Figure 3:
Connecting to the Network
To Network Device
To Network Device
A
B
A
A
B
B
OUT
OUT
OUT
OUT
IN
IN
LASER
CAUTION!
Splitter Tap
Splitter Tap
www.netoptics.com
Advertising