Net Optics 10 GigaBit Media Converter - Manual (Page 6)

3
10 GigaBit Media Install Guide
Installing a Conversion Kit
Installing the Media Converter
Warning: ______________________________________________________________________________________
The intended use of this product is in systems that contain lasers.
________________________________________________________________________________________________
DANGER: ______________________________________________________________________________________
Invisible Laser Radiation when open or when operating with fiber disconnected. AVOID DIRECT EXPOSURE TO THE
BEAM. Never operate unit with a broken fiber or with a fiber connector disconnected.
________________________________________________________________________________________________
To install the Converter:
1. If you are rack mounting the Converter, install the panel in the rack with the four thumbscrews provided.
2. Insert the Converter into one of the available slots and secure it to the panel by tightening the thumbscrews.
3. Using the supplied cables, connect the Converter ports to the corresponding devices.
4. Connect the redundant power supplies to separate power sources and then to the converter.
5. Secure the DC power connectors with the connector clips.
6. Check the Power LEDs to verify that the Converter is receiving power.
7. Check the Link LEDs to verify that the link has been established.
Installing a Conversion Kit
The conversion kits include the XFP and matching cable. Remove power from the Converter before installing the
conversion kit.
To change the XFP:
1. Remove the cable and lower the wire clip to release the old XFP.
2. With the clip in the lowered position, pull gently on the clip to free the XFP.
3. Insert the new XFP until you hear it click into place.
4. Connect the approriate cable and check the Link LEDs.