Net Optics GigaBit SX_LX to TX Tap - Manual (Page 11)

GigaBit SX/LX to TX Tap
7
Connecting to the Monitoring Device
1 . Supply power to the Tap using the two redundant power supplies included
with the unit . Verify that the Power LED illuminates .
2 . Connect Monitor Port A to the appropriate port on the monitoring device
using a CAT5e straight-through cable .
3 . Connect Monitor Port B to the appropriate port on the monitoring device
using a CAT5e straight-through cable .
Note: _______________________________________________________________
The second power supply is available to support the flow of traffic to the
monitoring device in the event that the first power supply becomes
unavailable.
______________________________________________________________________
Figure 5: Connecting to the Monitoring Device
www.netoptics.com
Network
1
2
ACT
LINK
GigaBit
Converter Tap
GigaBit
Converter Tap
A B
Monitor A B
A B
ACT LINK ACT LINK
LASER
CAUTION!
To monitoring device NIC
To monitoring device NIC