Connecting to the network, Fiber tap hd8, Figure 2: connecting to the network – Net Optics Fiber Tap HD8 User Manual
Page 9
Fiber Tap HD8
5
Connecting to the Network
1 . Connect Network Port A to the appropriate network device using a Duplex
LC cable .
2 . Connect Network Port B to the appropriate network device using a Duplex
LC cable .
3 . Verify that the Tap Network Ports are cabled in-line between two devices .
4 . Repeat steps 1-3 as needed for remaining segements .
Note: ________________________________________________________________
The use of Singlemode (8.5µm) or Multimode (50µm or 62.5µm) cabling is
determined by the model purchased.
______________________________________________________________________
Figure 2: Connecting to the Network
To Network Device
To Network Device
Splitter Tap HD8
Splitter Tap HD8
www.netoptics.com
A
B
A
A B
B
OUT
IN
OUT
IN
OUT OUT
A
B
A
A B
B
OUT
IN
OUT
IN
OUT OUT
A
B
A
A B
B
OUT
IN
OUT
IN
OUT OUT
1
2
4
3