Asus RS740-E7-RS24-EG - Manual (Page 27)

2-3 ASUS RS740-E7-RS24-EG
1 2
2.1.1 Air Duct
The RS740-E7-RS24-EG server system comes with a motherboard fan air duct to enable
better air flow inside the motherboard while the system is running.
1. Remove the chassis cover. Refer to
section 2.1 Chassis cover for the
instructions.
2. Remove the three screws securing the
air duct.
Set the three (3) screws aside for later
use.
3. Carefully lift the air duct out of the
chassis.
Removing the air duct
To remove the air duct:
1 2
To install the air duct:
1.
Position the air duct on top of the motherboard matching the three (3) screw holes on
the air duct to the three (3) holes on the motherboard as indicated in the illustration
below.
C B
A
2. Tighten the screws one by one with a Phillips screwdriver. Use just enough force to
attach the air duct to the motherboard.
• Do not over tighten the screws to avoid damaging the motherboard and the air duct.
• Ensure that the air duct is firmly fitted to the motherboard.
Installing the air duct
A B
C
2
2
2
3