Asus TS100-E5/PI4 - Manual (Page 30)

Chapter 2: Hardware setup 2-12
2.5 Installing hard disk drives
The server system supports four Serial ATA hard disk drives through screw-free
hard disk drive holders.
To install a Serial ATA hard disk drive
1. Follow the instruction in section
2.1.2 Removing the right side
cover to remove the right side
cover.
2. Slightly push inward the HDD
holder handles to release the HDD
holder lock from the HDD bay, as
shown in the right figure.
3. Carefully pull the HDD holder out of
the HDD bay, as shown in the right
figure.
2
2
3
4. Locate the four pin caps on the
HDD holder. Align one side of the
HDD screw holes to one side of
the cage pin caps, as shown in the
right figure.
Pin cap
4
5. Follow the direction of the arrow in
the right figure and slightly bend
the HDD holder.