Asus TS100-E5/PI4 - Manual (Page 49)

3-9 ASUS TS100-E5/PI4
2. ICH7R Primary IDE connector (40–1 pin PRI_IDE1 and PRI_IDE3) –1 pin PRI_IDE1 and PRI_IDE3) 1 pin PRI_IDE1 and PRI_IDE3)
The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There
are three connectors on each Ultra DMA 133/100 signal cable: blue, black,
and gray. Connect the blue connector to the motherboard’s IDE connector,
then select one of the following modes to configure your device.
®
P5BV-C/4L/TS100-E5
P5BV-C/4L/TS100-E5 IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE1
PI
N
1
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE3
PIN 1
• Pin 20 on the IDE connector is removed to match the covered hole on
the Ultra ATA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80 – conductor IDE cable for Ultra ATA 100/66/33 IDE devices.
Drive jumper setting
Mode of
device(s)
Cable connector
Single device Cable-Select or Master - Black
Two devices
Cable-Select
Master
Black
Slave Gray
Master Master
Black or gray
Slave Slave
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.