Asus TS100-E5/PI4 - Manual (Page 38)

Chapter 2: Hardware setup 2-20
2.8 Removing components
You may need to remove previously installed system components when installing
or removing other system components, or when replacing a defective component.
This section tells how to remove the following components:
1. Floppy disk drive (FDD)
2. System fan
2.8.1 Removing the floppy disk drive
To remove the FDD
1. Disconnect the FDD power plug and signal cable.
2. Remove all four screws on the both
side of the FDD bay.
3. Carefully pull the FDD bay from the
chassis.
4. Remove the four screws from the
FDD bay to release the FDD.