Asus TS100-E5/PI4 - Manual (Page 55)

3-15 ASUS TS100-E5/PI4
11. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a
jumper cap. Remove the jumper caps only when you intend to use the chassis
intrusion detection feature.
®
P5BV-C/4L/TS100-E5
P5BV-C/4L/TS100-E5
Chassis Intrusion Connector
CHASSIS
+5VSB_MB Chassis Signal GN
D
(Default)
®
P5BV-C/4L/TS100-E5
P5BV-C/4L/TS100-E5
TPM Connector
TPM
3.3V AD
0
PWRDW
#
AD
1
AD
2
SERIRQ# CLKRUN#
NC
GN
D
PCICLK FRAME#
NC
PCIRST
#
AD
3
GN
D
3.3VSB
GN
D
NC NC
12. TPM connector (20- pin TPM)
This connector is used to connect a Trusted Platform Module (TPM) Card.
You need to install ASUS TPM card to use this feature function.
The TPM module is purchased separately.