Asus TS150-E2 - Manual (Page 112)

C h a p t e r 6 : R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n C h a p t e r 6 : R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n C h a p t e r 6 : R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n C h a p t e r 6 : R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n C h a p t e r 6 : R A I D c o n f i g u r a t i o n a n d d r i v e r i n s t a l l a t i o n 6 - 4 6 - 4 6 - 4 6 - 4 6 - 4
6.1.5 6.1.5 6.1.5 6.1.5 6.1.5 Intel Intel Intel Intel Intel ® ® ® ® ® Application Accelerator RAID Application Accelerator RAID Application Accelerator RAID Application Accelerator RAID Application Accelerator RAID
Option ROM Utility Option ROM Utility Option ROM Utility Option ROM Utility Option ROM Utility
The Intel ® Application Accelerator RAID Option ROM utility allows you to
create RAID 0 and RAID 1 set(s) from SATA hard disk drives that are
connected to the SATA connectors supported by the motherboard
Southbridge chip.
To enter the Intel ® Application Accelerator RAID Option ROM utility:
1. Turn on the system after installing all the SATA hard disk drives.
2. During POST, press <Ctrl+I> to display the utility main menu.
[ DISK/VOLUME INFORMATION ]
RAID Volumes:
None defined.
Non-RAID Disks:
Port Drive Model
Serial # Size Type/Status (Vol ID)
0 ST380013AS xxxxxxxx 74.5GB Non-RAID Disk
1 ST380013AS xxxxxxxx 74.5GB Non-RAID Disk
Intel(R) Application Accelerator RAID Option ROM v4.0.0.6211
Copyright(C) 2003-04 Intel Corporation. All Rights Reserved.
[ MAIN MENU ]
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
[ ]-Select [ ]-Select [ESC] Exit [ESC] Exit [Enter]-Select Menu [Enter]-Select Menu
The RAID BIOS setup screens shown in this section are for reference
only, and may not exactly match the items on your screen.
At the bottom of the screen are the navigation keys. These keys allow
you to move through the menus and select the menu options.
[ ]-Change [ ]-Change [TAB]-Next [TAB]-Next [ESC] Previous Menu [ESC] Previous Menu [Enter]-Select [Enter]-Select